[Chimera-users] Fitting models into density - meaning of values

Tom Goddard goddard at sonic.net
Tue Oct 29 18:22:32 PDT 2013

Hi Jessica,

  The "average map" value reported by Chimera is only useful for comparing different fits in the same map.  The values in a density map normalized in ways that differ from map to map, so the absolute value is meaningless.  What is sometimes reported in the literature is correlation coefficient, ranging from -1 to 1.  The Chimera fitting will report this if you use the Options button on the Fit Map dialog and enable "Use simulated map … with resolution 23".  The correlation compares a simulated map from your atomic model to the experimental map.  Values like 0.8 and higher are often considered "good".  But unfortunately this is a very poor indicator too for several reasons.  First it depends on the region in space over which the correlation was measured.  In Chimera this will be the grid points within the displayed contour of the simulated map.  (You'll have to show the simulated map using the volume dialog or model panel to see that contour level.)  Higher contour levels use fewer grid points and often give a much higher correlation value.  Another reason this is a poor measure is that it doesn't tell you if there are 5 other very different fits with equally good correlation value.  For a low resolution map like 23 Angstroms, there may be many equally good and very different fits.  The short answer is that it is hard to say if a fit to a low resolution map is good in a convincing way, and the research community does not have standard measures for this.  To make your best effort I would try to produce 2nd and 3rd best fits and see if the 1st best one stands out as a visibly better match (and corresponding higher correlation) than the 2nd and 3rd best fits.


On Oct 29, 2013, at 5:57 PM, Jessica Holien  wrote:

> I have been using Chimera to fit some homology models into the EM density (23A resolution) of a large complex. Although by eye it looks good I am trying to work out if statistically it is good. Can anyone tell me what is a good "Average Map Value" and what is a bad one? Thanks
> _______________________________________________
> Chimera-users mailing list
> Chimera-users at cgl.ucsf.edu
> http://plato.cgl.ucsf.edu/mailman/listinfo/chimera-users

More information about the Chimera-users mailing list