[Chimera-users] single-component calculation

Elaine Meng meng at cgl.ucsf.edu
Thu Dec 17 08:47:55 PST 2009

Dear Richard,
You can turn off warning dialogs in the preferences (Favorites...  
Preferences):  in category "Messages" you can specify that warning  
messages be sent to the "reply log only."  You can also do that for  
error messages, but I believe that this particular surface message is  
a warning.  Remember to click Save if you want the setting to  
propagate to later uses of Chimera.

It may be that we didn't discuss these preferences on the list before,  
at least in connection with surface calculations.  Best,
Elaine C. Meng, Ph.D.
UCSF Computer Graphics Lab (Chimera team) and Babbitt Lab
Department of Pharmaceutical Chemistry
University of California, San Francisco

On Dec 17, 2009, at 12:00 AM, Marhoefer, R (Richard) wrote:

> Dear Elaine,
> I get the error most of the times when I run a surface calculation.  
> However, in more than 99.9% of all cases I run so far the outer  
> surface was ok. However, the popup window reporting the error caused  
> me some trouble sometimes. When I try to record a movie the window  
> sometimes pops in front of the chimera graphics window and is  
> therefore also rendered into the movie, which does not look very  
> nice ;-)
> Is it possible to switch off the popup window? It would be  
> sufficient for me if the error message would be written to the reply  
> log.
> I beg your pardon if you mentioned the answer in any of the previous  
> posts you mentioned. I read through all of them but couldn't find a  
> solution.
> Mit freundlichen Grüßen / With kind regards
> Dr. Richard Marhoefer
> Senior Scientist BioChemInformatics
> Intervet Innovation GmbH
> Zur Propstei
> 55270 Schwabenheim, Germany

More information about the Chimera-users mailing list