Subject: Re: Peaklist transfer
From: woonghee_lee
Date: Sep 21, 2017

Previous: 1275

If you see unlabelable, see the box below. They are not used to label. If you see only Assignments w1 w2..., just ignore.

There are a few ways adjust offsets. You can choose depending on your state.

- If the shift is uniform and you really dont need to move your peaks after read-in, you can use st to set offset before reading peak lists in and use st again to move that back.

- Or, you just peak picks first (using APES maybe ?), and use rp to label peaks not to create peaks. Tolerance setting should cover drifting.

- Another way is, if shifts are minimal, just read peak list in, and select all the peaks pa and center all the peaks pc. This option is risky because peaks may move to the other position rather than desired.

There must be other methods that people prefer I think.

Best,
Woonghee